34320 Data Path Control DPC: SCSI Driver Error, line <Line Number> Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 The firmware's SCSI driver encountered an unexpected error situation. The <line number> should be recorded and reported to the responsible firmware programmer along with a description of the circumstances surrounding the error. The SCSI hardware (i.e. cables, workstation card, DPE, etc) should be checked as outlined in the Service Manual Troubleshooting Guide. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. SCSI hardware (i.e. cables, workstation card, MCE or DNE, etc) Line Number The parameter token in the error string refers to the line number within the SCSI driver code where the driver error was detected. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:03 2008 PST